POLYMER MODIFIED GROUT MERGED
For wall and floor tile/stone joints
A high quality polymer-modified, water resistant, cement based grout designed for grouting glazed wall tiles, porcelain tiles, mosaic, vitrified & fully vitrified tiles, natural and engineered stones.
Cleaning
Tools and containers may be cleaned using clean water when the adhesive is still fresh. The hardened adhesive can be removed from tools mechanically.
Storage And Shelf Life
POLYMER MODIFIED GROUT has a shelf life of 12 months when stored in normal dry conditions.
Colours
Available in range of colours.
Features
1. Good bond strength
2. Water Resistant
3. For interior & exterior use
4. Suitable for joint width of 1-6mm
Mixing
Take pre-measured water in a clean mixing vessel. Add POLYMER MODIFIED GROUT in the vessel and mix until a lump free smooth paste of uniform colour is obtained. If an electric drill mixer is used blend ona slow speed (less than 300rpm). Avoid entraining air by mixing at too high speed or by over mixing. Do not reconstitute the mixed grout by adding more water as this will reduce the final strength.
Physical Properties
| Polymer Modified Grout | @27+1°C |
|---|---|
| Joint Width | 1-6mm |
| Pot Life | 30 minutes |
| Curing Time | 24 hours |
| Temperature Resistance | -30°C to 150°C |
| Mixing Ratio | Water : Grout 1:3 |
| 24 hours | min. 4.00 kN |
| 48 hours | min. 8.00 kN |
| VOC Content | 5.15 g/L |