TILE ON TILE ADHESIVE
Ready to use grey cement based non-shrink, Self cur-ing tile adhesive for fixing tile on wall and floor.
Fixing ceramic tiles on floor and wall surfaces.
Johnberg must be mechanically mixed using a forced action mixer or in a clean container using a drill and mixing paddle (<500rpm). A normal concrete mixer is not suitable.
Mix thoroughly with clean water for a minimum of 3 minutes.
CHARACTERISTICS / ADVANTAGES
1. Ready to use, only water to be added.
2. Contains special chemicals to obtained non-shrink and excellent adhesion properties.
3. Better bond than conventional cement based mortar.
4. Fast setting and quick strength development
5. Self curing
6. Good mechanical strength
7. Suitable for fixing Ceramic tiles on wall and floor
12 Months from the date of manufacturing.
|Shelf Life||12 months from date of manufacturing if stored properly in original, un-opened and undamaged sealed pack.|
|Storage Conditions||To be stored properly in dry conditions and not under direct sunlight|
|Density||~ 1.4 kg/I (at +279 C)|
|Shear Adhesion||Type 1 Adhesive (as per IS 15477 Standard)|
|Mixing Ratio||Water : Powder = 0.22 to 0.24 by weight (6.6 Lto 7.2 L water per 30kg bag)|
|Consumption||~2.5-3 kg powder required / Sqm for 3mm average thickness. ~100-120 Sq ft is covered by a bag of 30kg for 3mm thickness depending on the substrate level.|
|Layer Thickness||3mm minimum|
|Ambient Air Temperature||+59C min. / +45°C max.|
|Substrate Temperature||+59C min. / +459C max.|